Nmea Data; Using The Seatalk Auxiliary Junction Box - Raymarine RAY230E Owner's Handbook Manual

Installation
speaker will function simultaneously with the internal speaker.

2.4.3 NMEA Data

2.4.3 NMEA Data 2.4.3 NMEA Data
2.4.3 NMEA Data 2.4.3 NMEA Data
The RAY230/E accepts NMEA 0183 data from a position determining device
(GPS, Loran, etc.) to provide the Latitude and Longitude position
information that is transmitted during a DSC Distress Call. The NMEA
sentences that provide positional data, by order of priority are: GGA, RMC,
RMA, and GLL.
Connect the input(s) of the positioning device to the white (NMEA+) and
black (NMEA-) wires in the Power/Hailer/NMEA cable.
For example, to connect a Raymarine Heading Sensor to the NMEA input,
connect the cables and power supply using a suitable connector block, as
shown in the diagram below. If installed, it may be convenient to connect
the power to the SeaTalk auxiliary junction box described in the following
section.
Note:
All return connections (-) must be tied to a common ground reference.
2.4.4 2.4.4 2.4.4
2.4.4 2.4.4
A junction box is used to connect the SeaTalk instrument system to the
RAY230. This junction box enables the SeaTalk bus, power and GPS to be
connected.
If power is not already available (via another SeaTalk instrument), the
junction box can be used to apply power to the SeaTalk bus for other
applications. The junction box may also be used for connecting an NMEA
GPS system.
Figure 2-5 Figure 2-5 Figure 2-5 Figure 2-5 Figure 2-5 Sample GPS Connections Sample GPS Connections Sample GPS Connections Sample GPS Connections Sample GPS Connections

Using the SeaTalk Auxiliary Junction Box

Using the SeaTalk Auxiliary Junction Box Using the SeaTalk Auxiliary Junction Box
Using the SeaTalk Auxiliary Junction Box Using the SeaTalk Auxiliary Junction Box
Red
+12 V
Yellow
+ NMEA Data (white)
Black
-- NMEA Data (black)
0V
2-6