Operating Procedures; Turning On/Off The Power Supply - Raymarine RAY230E Owner's Handbook Manual

Operations

3.5 Operating Procedures

3.5 3.5 Operating Procedures Operating Procedures Operating Procedures
3.5 3.5 Operating Procedures
With the RAY230 and RAY230E, all operations are made on the Handset
except turning ON/OFF the main power supply and adjusting the sound
volume of the External Speaker.
3.5.1 Turning ON/ OFF the Power Supply 3.5.1 Turning ON/ OFF the Power Supply
3.5.1 Turning ON/ OFF the Power Supply 3.5.1 Turning ON/ OFF the Power Supply 3.5.1 Turning ON/ OFF the Power Supply
To power on the RAY230/E:
1) Press the main power supply button located on the top of the base
station transceiver (main unit). A light illuminates the button when
power is ON.
The main unit and the handset(s) will then be in a standby power
condition; the radio circuitry does not yet have power.
2) Press the 16/9 key on any handset. The full system is powered ON.
Note:
If the main power supply switch is OFF, the handsets cannot power the
system ON.
If the main power supply switch is ON and multiple handsets are connected,
pressing the FUNC and 16/9 key from one handset will fully power ON
the system and all handsets.
To power off the RAY230/E:
1) Press the FUNC key followed by the 16/9 key on any handset. The
main unit and all handset(s) return to the standby condition.
2) Switch OFF the main power supply. The light illuminating the button
goes out. Full system power is OFF.
Note:
If multiple handsets are connected, initiating power OFF from one handset
will cause all the handsets (and main unit) to enter the standby condition.
Power OFF can be only be initiated from the handset that has priority.
See section 3.5.23 below.
3-13