(Transmitter, All Channel Receiver); Modulation Adjustment (Transmitter); Output Power Adjustment (Transmitter) - Raymarine RAY230E Owner's Handbook Manual

5-4
5.3.1 5.3.1 5.3.1
5.3.1 5.3.1

(Transmitter, All Channel Receiver)

(Transmitter, All Channel Receiver) (Transmitter, All Channel Receiver)
(Transmitter, All Channel Receiver) (Transmitter, All Channel Receiver)
1) Connect the power supply (13.2V, 10A) to the DC Power Line.
2) Connect the RF Power Meter and a Frequency Counter through the
coupler.
3) Turn the radio "ON" and select Channel 16 (156.800 MHz).
4) Press PTT on the Handset and read the indication on the Frequency
Counter.
5) Adjust trimmer capacitor (TC1) on the RF PCB (see Fig 5-2) for the
desired frequency (156.800 MHz) +/- 100 MHz.
5.3.2 Local Oscillator Adjustment (Channel 5.3.2 Local Oscillator Adjustment (Channel 5.3.2 Local Oscillator Adjustment (Channel
5.3.2 Local Oscillator Adjustment (Channel 5.3.2 Local Oscillator Adjustment (Channel
70 Receiver) 70 Receiver) 70 Receiver)
70 Receiver) 70 Receiver)
1) Connect a Frequency Counter to TP1 on the RF PCB and GND.
2) Set the radio on Channel 16 and adjust trimmer capacitor (TC2) on the
RF PCB for the desired frequency (139.625 MHz) +/- 100Hz.

5.3.3 Modulation Adjustment (Transmitter)

5.3.3 Modulation Adjustment (Transmitter) 5.3.3 Modulation Adjustment (Transmitter)
5.3.3 Modulation Adjustment (Transmitter) 5.3.3 Modulation Adjustment (Transmitter)
1) Connect an FM Linear Detector through the coupler.
2) Connect the Audio Oscillator to the IDC input (pin 15 of J2) as shown
in Fig 5-3.
3) Set the AF OSC output to 0 dBm (0.77 Vrms) at 1 kHz.
4) Press PTT and adjust VR3 on the RF PCB to the maximum modulation
of 4.5 kHz +/-100 Hz.5.3.4

5.3. Output Power Adjustment (Transmitter)

5.3. Output Power Adjustment (Transmitter)
5.3. Output Power Adjustment (Transmitter) 5.3. Output Power Adjustment (Transmitter) 5.3. Output Power Adjustment (Transmitter)
1) Connect the RF Power meter.
2) Set the radio on CH 16 (156.800 MHz) .
3) Transmit and adjust the RF power output by VR1 (Low) and VR2 (High)
on the RF PCB as follows.
S e q u e n c e S e q u e n c e S e q u e n c e S e q u e n c e S e q u e n c e
PLL PLL PLL
PLL PLL
RF Power RF Power Adjust Point RF Power RF Power RF Power
1 Low
2 High
Frequency Frequency Frequency
Frequency Frequency
Adjust Point Adjust Point Adjust Point Adjust Point Target Target Target Target Target
VR1 0.9W +/- 0.05W (limit 1W)
VR2 24W +/-0.5W (limit 25W)
Maintenance
Adjustment Adjustment Adjustment
Adjustment Adjustment
Power Power Power Power Power