Transmitting An All Ships Call - Raymarine RAY230E Owner's Handbook Manual

3-38
If ENT is pressed, the alarm is turned off, and a new prompt appears on the
display, instructing you to press the PTT switch. Press PTT to transmit. If
PTT is not pressed within 5 seconds of the prompt appearing, the
transmission is done automatically. Pressing the PTT switch causes the
channel to change to the communication channel.
If the CLR key is pressed, the alarm is turned off, the displays are cleared,
and the received contents are stored in the Log File. The radio then reverts
to the operation mode before receiving the Individual Call. DSC will
continue flashing to indicate there is an unread call in the log.

3.5.26.5 Transmitting an All Ships Call

3.5.26.5 Transmitting an All Ships Call 3.5.26.5 Transmitting an All Ships Call
3.5.26.5 Transmitting an All Ships Call 3.5.26.5 Transmitting an All Ships Call
The All Ships Call is classified in two categories: Safety Call and Urgency
Call.
To send an All Ships Call
1) Press the ALL SHIP key. The DSC indicator is displayed, and the
message SAFETY appears on the dot matrix display.
2) Press the SQ UP/DOWN key. The message URGENCY now appears on
the dot matrix display.
3) Make you selection between SAFETY or URGENCY and press the
ENT key to submit. The prompt RECONFIRM is displayed.
4) Press the ENT key to confirm. A prompt appears on the display,
instructing you to press the PTT switch.
5) Press PTT to transmit the call.
The All Ships Call is made on Channel 16. The transmission power is 1W
for a SAFETY Call and 25W for an URGENCY Call.
Alternate by pressing the
SQ UP/DOWN key
Receiving
Scrolling every 1 sec
ENT
Operations
ENT
Automatic transmission is
done if MMSI No. is not listed.
ENT