Using The Tyre Pressure Monitor; Storing Wheels; Restarting The Tyre Pressure Monitor (On-Board Computer With A Monochrome Display); Restarting The Tyre Pressure Monitor (On-Board Computer With Colour Display) - SMART forfour Owner's Manual

Vehicles with steel wheels and hub caps:
X
Fit hub cap A such that valve B does not
become trapped.
X
Press the hub cap evenly onto the wheel
with both hands until you hear the hub cap
engage.
X
Check to make sure the hub cap is seated
securely on the wheel.
Vehicle with steel wheels and wheel hub cov-
ers:
X
Fit the wheel hub cover.

Storing wheels

X
Store wheels in a cool, dry and dark place
when not in use.
X
Protect against oil, grease and fuel.

Using the tyre pressure monitor

Useful information
It is the driver's responsibility to set the tyre
pressure to the recommended cold tyre pres-
sure suitable for the operating situation.
The tyre pressure monitor issues a warning
when the pressure drops in one or more of the
tyres.
The tyre pressure monitor works properly
only if sensors are present in all four tyres,
and after the monitor has learned the correct
tyre pressure for the current operating sit-
uation. This occurs automatically in most
situations, but may also be specified after
restarting the tyre pressure monitor. Before
restarting, check the tyres for the recom-
mended tyre pressure.
Using the tyre pressure monitor
The tyre pressure monitor does not provide a
warning in the following cases:
Even loss of pressure on multiple tyres
R
Sudden loss of tyre pressure, e.g. due to
R
penetration by a foreign body
Incorrectly set tyre pressure
R
The tyre pressure monitor has a yellow
warning lamp in the instrument cluster for
indicating a pressure loss or malfunction.
Restarting the tyre pressure monitor
(on-board computer with a mono-
chrome display)
X
Set the tyre pressure of all tyres to the
recommended value.
X
On the multifunction lever press the ´
button repeatedly until the ° and h
symbols are displayed in the instrument
cluster display.
X
Press and hold the a button on the mul-
tifunction lever.
The ° and h symbols will flash in
the instrument cluster display for about
5 seconds. The two symbols then light up.
The tyre pressure monitor is restarted.
Restarting the tyre pressure monitor
(on-board computer with colour dis-
play)
X
Set the tyre pressure of all tyres to the
recommended value.
X
Settings Tyre pressure monitor
Select >
in the on-board computer.
Tyre pressure monitor Adopt cur‐
The
rent pressures as new reference val‐
ues?
message appears in the display.
X
yes
Select and press a to confirm.
The display shows the
monitor restarted
Tyre pressure monitor restarted
If the
message does not appear after 5 seconds,
repeat the tyre pressure monitor restart.
Tyre pressure
message.
Z
155