Configuring the SNMP Access Control List
You can use the SNMP Access Control List to set up a list of hosts that are authorized to access the
printer.
To configure the Host Access List:
1.
In CentreWare Internet Services, click Properties > Protocols.
Click SNMP.
2.
3.
For Host Access List, type up to 10 host IP addresses. Separate Host Access List entries with a blank
or a comma, or to specify a range, use a hyphen. To represent a group of addresses, for example
13.62.156.*, use an asterisk.
4.
Separate Host Access List entries with a blank or a comma, or to specify a range, use a hyphen.
Click Save Changes.
5.
Disabling and Enabling SNMP
If SNMP is not needed, to prevent unauthorized access to the printer, you can disable it in CentreWare
Internet Services.
If you disable SNMP, the following print driver features are also disabled.
•
Walk-Up Installer
•
Smart Trays
•
PhaserSMART
•
Automatic supplies ordering
•
Consumable levels
•
Warning and error status
•
Synchronization with installed options, including a hard drive, memory, or extra trays
To disable or enable SNMP:
In CentreWare Internet Services, click Properties > Protocols.
1.
2.
Click SNMP.
For SNMP Enable/Disable, click Disable SNMP Now or Enable SNMP Now.
3.
4.
Click OK.
®
Xerox
ColorQube 8580/8880 Color Printer
System Administrator Guide
Network Connectivity
41