Configuring The Snmp Access Control List - Xerox 7400DXF - Phaser Color LED Printer Administrator's Manual

8. Click the Configure Account(s) button. A series of pages display that enable you to
configure SNMP v3 and the Administrative User, Key User, and Any User/Driver
settings. The first page displays Administrative User account information after the account
has been created.
9. Do one of the following:
■ To create the Administrative User account and to enable SNMP v3, enter a user name
or accept the default name admin, and then click the Create button.
To configure the Key User and other account settings, click the Next button.
■
■ To delete the Administrative User account and disable SNMP v3, click the Delete
button. This also deletes all other accounts, including the Key User and Any User
settings.

Configuring the SNMP Access Control List

To set up a list of hosts that are authorized to access the printer using SNMP:
1. Launch your web browser.
2. Enter your printer's IP address in the browser's Address field (http://xxx.xxx.xxx.xxx).
3. Click Properties.
4. Select the Protocol folder on the left sidebar.
5. Select SNMP.
6. If prompted, enter your Admin or Key User name and password.
7. Enter up to ten host IP addresses in the SNMP Access Control List field. Separate entries
with a blank or a comma, specify ranges with a hypen (-), and use an asterisk (*) to
represent a group of numbers (e.g., 13.62.156.*).
8.
Click the Save Changes button.
9.
If prompted, enter your Admin or Key User name and password.
See also:
About Access Control Lists on page 4-4
System Administrator Guide
4-18
Configuring SNMP