Configuring The Snmp Access Control List; See Also - Xerox 7760DN - Phaser Color Laser Printer Administrator's Manual

The Any User/Driver Account Settings
■ User Name: Displays anyuser by default and cannot be changed.
■ MIB Access: Displays the Any User account's MIB access permissions selected on the
Configure SNMP v3: Other Account Settings page. This can be set to Read or
Read/Write.
■ SNMP Read: Displays a check symbol if SNMP Read access is enabled. SNMP Read
access can be enabled for the Any User account after the Key User account is created.
■ SNMP Write: Displays a check symbol if SNMP Write access is enabled. SNMP Write
access can be enabled for the Any User account after the Key User account is created.
■ Driver Account Enabled: Displays a check symbol if the Driver Account is enabled
(default).
Note:
If the Driver Account is disabled, it breaks communication between the printer and
any applications using SNMP v3, such as Xerox printer drivers and PrintingScout. For a
complete list of applications disabled, see

Configuring the SNMP Access Control List

To set up a list of hosts that are authorized to access the printer using SNMP:
1. Launch your web browser.
2. Enter your printer's IP address in the browser's Address field (http://xxx.xxx.xxx.xxx).
3.
Click Properties.
4. Select the Protocol folder on the left sidebar.
5.
Select SNMP.
6. If prompted, enter your Admin or Key User name and password.
7.
Enter up to ten host IP addresses in the SNMP Access Control List field. Separate entries
with a blank or a comma, specify ranges with a hypen (-), and use an asterisk (*) to
represent a group of numbers (e.g., 13.62.156.*).
8. Click the Save Changes button.

See also:

About Access Control Lists
Disabling SNMP
on page 4-4
System Administrator Guide
4-19
Configuring SNMP
on page 4-20.