ACME Genesis move 25R User Manual page 14

ENTER button and the display will blink. Use DOWN and UP button to select the
(Led on) or (Led off) mode. Once the mode has been selected, press the ENTER
button to setup or automatically return to the main functions without any change after 8
seconds. To go back to the functions without any change press the MENU button again.
Display Inversion
It is good for you to install the unit on the floor or under ceiling. Press the MENU button up to
when the is blinking on the display. Use the ENTER button to change to the mode
(display normal), It will automatically store after 8 seconds. Or press the ENTER
button again return to the mode
press the MENU button.
Display normal mode for the fixture putting on the floor.
Display inversion mode for the fixture fixing under ceiling.
Focus Adjust
Press the MENU button up to when the
button to change orientation of the light, then you can turn the plastic lens manually to adjust
the focus of the unit. To go back to the functions press the MENU button again.
Self-Test
Press the MENU button up to when the
button and the unit will run self-test by built-in program. To go back to the functions press the
MENU button again.
Temperature Test
Press the MENU button up to when the
button and the display will show the temperature of the unit. To go back to the functions
press the MENU button again.
Fixture Hours
Press the MENU button up to when the
(display inversion). To go back to the functions
is blinking on the display. Pressing ENTER
is blinking on the display. Pressing ENTER
is blinking on the display. Pressing ENTER
is blinking on the display. Pressing ENTER
9- 6-