Cash Drawer - Epson TM-T88V-DT Technical Reference Manual

Cash Drawer

Connect the connector of the drawer kick-out cable to the printer.
Push the connector of the drawer kick-out cable into the product until you hear a click.
 Specifications of drawers differ a great deal, depending on makers or models. When you use a
drawer other than the specified, make sure its specifications meet the following conditions.
Otherwise, devices may be damaged.
WARNING
 The load, such as a drawer kick-out solenoid, must be connected between pins 4 and 2 or
 When the drawer open/close signal is used, a switch must be provided between drawer
 The resistance of the load, such as a drawer kick-out solenoid, must be 24
 Be sure to use the 24V power output on drawer-kick out connector pin 4 for driving the
 Use a shield cable for the drawer connector cable.
 Two driver transistors cannot be energized simultaneously.
 Leave intervals longer than 4 times the drawer driving pulse when sending it continuously.
 Be sure to use the printer power supply (connector pin 4) for the drawer power source.
 Do not insert a telephone line into the DK connector.
Doing so may damage the telephone line or printer.
 PC-POS System
The cash drawer is controlled from this product's printer. There is no dedicated driver for the cash drawer -
you can use the printer driver.
 Systems that use TM-DT software
The cash drawer is controlled from this product's printer. Configure the printer to use.
pins 4 and 5 of the drawer kick-out connector.
kick-out connector pins 3 and 6.
input current must be 1A or less.
equipment.
Chapter 2 Printer Functions and Settings
DK connector
2

or more or the
42