Software Access Point - Epson TM-T88V-DT Technical Reference Manual

Software Access Point

TM-DT software is equipped with a software access point that enables communication with a tablet terminal
using the wireless LAN cable set (OT-WL01) as the access point. A smart device and this product can directly

communicate by Wi-Fi even in an environment where there is no router or network. You can construct a small
POS system or a kitting system where no display or keyboard is connected to this product.
Communication Settings
1
Turn the product power on and connect the wireless LAN cable set (OT-WL01).
2
The printer prints the SSID and password.
3
Configure Wi-Fi with the tablet terminal. Configure using the printed SSID and pass-
word. Communications will be established with this product in a few minutes.
This product can be controlled on the following networks.
Setting Value
(Cannot be changed)
IP address
Subnet mask
Setting Items
Setting
Enabling / Disabling ePOS-Device Service 
page 64 page 70
( , )
Software Access Point ( page 106
192.168.173.1
255.255.255.0
 Enabling ePOS-Device Service
 Enable
)
 SSID
 Password
Chapter 4 System Development Using TM-DT Software
Item
Items
4
81