Functions - Epson TM-T88V-DT Technical Reference Manual

Functions

Paper width
Be sure to install the roll paper guide when you select the 58 mm paper width.
 80 mm (initial setting)
 58 mm
Once you change the paper width from 80 mm to 58 mm, you cannot change it back to 80 mm.
Print density
Selectable from "Depends On Dip Switch", or levels 1 to 13 (70% ~ 130%)
When the print density setting is configured to "Depends On Dip Switch" (default setting), the
print density will be standard. Use in this setting at normal times. Other settings can also be con-
figured.
Multiple tone density
Selectable from levels 1 to 13 (70% ~ 130%) (initial setting: level 7)
 First change the print density, and then configure the multiple tone print density.
 If you set the density too high, the contrast becomes lower. Select the density level checking
the overall tone balance of your image.
Print speed
Selectable from levels 1 to 13 (Slow ~ Fast) (initial setting: level 13)
Depending on print conditions, such as print duty and print head temperature, print speed is
automatically adjusted, which may cause white lines due to intermittent print (the motor some-
times stops). To avoid this, keep the print speed constant by setting it lower.
Font
 Code page: Selectable from 43 pages
 International character set: Selectable from 18 sets
 Font A/B replacement
External optional buzzer settings
Not used with this product.
Chapter 2 Printer Functions and Settings
2
55