Connecting the Cash Drawer
Connect the connector of the drawer kick cable to the printer.
Push the connector of the drawer kick cable into the product until you hear a click.
WARNING
• Systems that use TM-DT software
The cash drawer is controlled from this product's printer. Configure the printer to use.
• PC-POS System
The cash drawer is controlled from this product's printer. There is no dedicated driver for the
cash drawer you can use the printer driver.
• Specifications of drawers differ a great deal, depending on makers or models. When you use a
drawer other than the specified, make sure its specifications meet the following conditions.
Otherwise, devices may be damaged.
∗ The load, such as a drawer kick solenoid, must be connected between pins 4 and 2 or pins 4
and 5 of the drawer kick connector.
∗ When the drawer open/close signal is used, a switch must be provided between drawer kick
connector pins 3 and 6.
∗ The resistance of the load, such as a drawer solenoid, must be 24
rent must be 1A or less.
∗ Be sure to use the 24V power output on drawer kick connector pin 4 for driving the equip-
ment.
• Use a shield cable for the drawer kick cable.
• Two driver transistors cannot be energized simultaneously.
• Leave intervals longer than 4 times the drawer driving pulse when sending it continuously.
• Do not insert a telephone line into the drawer kick connector.
Doing so may damage the telephone line or printer.
We recommend using an optional product for TM printers.
Chapter 2 Setup
Drawer kick connector
Ω
or more or the input cur-
2
27