Specifications - Bosch CL200 User Manual

R200, R200P, COM2-E Communication Modules
11–6
Module slots
Ethernet address / IP address
Special function modules
11.2

Specifications

D Scanner
D Printer
1 2 3 4 5 6 7
Basic unit
Each COM2-E module comes with its own unique Ethernet address. This
address is unique in the world, and should not be changed. In addition, to
address the module via the Ethernet, an Internet address (IP address) is re-
quired. IP addresses are allocated by the network administrator. The IP ad-
dress may occur only once throughout the connected LAN.
To enable the COM2-E to be addressed from within the PLC program, spe-
cial function modules must be integrated in the PLC program. The modules
are designated R2REQ and R2CON (order no. 1070 077 901).
Specifications R200
Order no. 1070 077 145
Interfaces D V.24
D V.24 / 20mA
Baud rates
D RS-485 interface
D V.24 / 20mA
interface
600 to 57600 baud
D Ethernet
interface
Current draw I 250 mA without use
Sys
of 20 mA interface
500 mA with use of
20 mA interface
Width 1 slot
GG3-K
R200P COM2–E
1070 077 285 1070 080 557
D RS-485 D 10BaseT
(Ethernet)
D V.24 / 20mA
D V.24 / 20mA
9.6 kbaud to 9.6 kbaud to
12 Mbaud 12 Mbaud
600 to 57600 Baud 600 to 57600 Baud
max. transmission
rate 10 Mbit/s
500 mA 500 mA
1070 072 145-102 (01.07) GB