The Wmm Screen - ZyXEL Communications AMG1312-T10D User Manual

Figure 36 Network Setting > Wireless > WDS
The following table describes the labels in this screen.
Table 18 Network Setting > Wireless > WDS
LABEL
WDS Security
TKIP
AES
#
Active
Remote Bridge
MAC Address
PSK
Apply
Cancel

6.7 The WMM Screen

Use this screen to enable or disable Wi-Fi MultiMedia (WMM) wireless networks for multimedia
applications.
Click Network Setting > Wireless > WMM. The following screen displays.
AMG1312-T10D User's Guide
DESCRIPTION
Select the type of the key used to encrypt data between APs. All the wireless APs
(including the Device) must use the same pre-shared key for data transmission.
The option is available only when you set the security mode to WPA2 or WPA2-PSK in
the Wireless > General screen.
Select this to use TKIP (Temporal Key Integrity Protocol) encryption.
Select this to use AES (Advanced Encryption Standard) encryption.
This is the index number of the individual WDS link.
Select this to activate the link between the Device and the peer device to which this
entry refers. When you do not select the check box this link is down.
Type the MAC address of the peer device in a valid MAC address format (six hexadecimal
character pairs, for example 12:34:56:78:9a:bc).
Enter a Pre-Shared Key (PSK) from 8 to 63 case-sensitive ASCII characters (including
spaces and symbols).
Click this to save your changes.
Click this to restore your previously saved settings.
Chapter 6 Wireless
65