ZyXEL Communications AMG1312-T10D User Manual page 176

Chapter 19 TR-069 Client
The following table describes the fields in this screen.
Table 79 Maintenance > TR-069 Client
LABEL
CWMP
ACS URL
ACS User Name Enter the TR-069 user name for authentication with the auto-configuration server.
ACS Password
Connection
Request Path
Connection
Request Port
Connection
Request User
Name
Connection
Request
Password
Inform
Inform Interval
Apply
Cancel
176
DESCRIPTION
Select Enable to allow the Device to be managed by a management server. Otherwise,
select Disable to not allow the Device to be managed by a management server.
Enter the URL or IP address of the auto-configuration server.
Enter the TR-069 password for authentication with the auto-configuration server.
Type the IP address or domain name of the Device. The management server uses this path
to verify the Device.
The default port for access to the Device from the management server is the HTTP port, port
80. If you change it, make sure it does not conflict with another port on your network and it
is recommended to use a port number above 1024 (not a commonly used port). The
management server should use this port to connect to the Device. You may need to alter
your NAT port forwarding rules if they were already configured.
Enter the connection request user name.
When the ACS makes a connection request to the Device, this user name is used to
authenticate the ACS.
Enter the connection request password.
When the ACS makes a connection request to the Device, this password is used to
authenticate the ACS.
Select Enable for the Device to send periodic inform via TR-069 on the WAN. Otherwise,
select Disable.
Enter the time interval (in seconds) at which the Device sends information to the auto-
configuration server.
Click Apply to save your changes.
Click Cancel to restore the screen's last saved settings.
AMG1312-T10D User's Guide