ZyXEL Communications AMG1312-T10D User Manual page 111

Table 42 Class Setup: Add/Edit (continued)
LABEL
To Queue
Criteria Configuration
Use the following fields to configure the criteria for traffic classification.
Basic
From Interface
Source
IP Address
IP Subnet Mask
Exclude
Port Range
Exclude
MAC Address
MAC Mask
Exclude
Destination
IP Address
IP Subnet Mask
Port Range
MAC Address
MAC Mask
Exclude
Others
Service
IP Protocol
AMG1312-T10D User's Guide
DESCRIPTION
Select a queue to apply to this class (available when you set Interface to From WAN).
You should have configured a queue in the Queue Setup screen already.
Select the interface from which the traffic class comes.
Select the check box and enter the source IP address in dotted decimal notation. A
blank source IP address means any source IP address.
Enter the source subnet mask.
Select this option to exclude the packets that match the specified criteria from this
classifier.
If you select TCP or UDP in the IP Protocol field, select the check box and enter the
port number(s) of the source.
Select this option to exclude the packets that match the specified criteria from this
classifier.
Select the check box and enter the source MAC address of the packet.
Type the mask for the specified MAC address to determine which bits a packet's MAC
address should match.
Enter "f" for each bit of the specified source MAC address that the traffic's MAC address
should match. Enter "0" for the bits of the matched traffic's MAC address, which can be
of any hexadecimal characters. For example, if you set the MAC address to
00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet with a MAC address of
00:13:49:12:34:56 matches this criteria.
Select this option to exclude the packets that match the specified criteria from this
classifier.
Select the check box and enter the destination IP address in dotted decimal notation. A
blank source IP address means any source IP address.
Enter the destination subnet mask.
If you select TCP or UDP in the IP Protocol field, select the check box and enter the
port number(s) of the source.
Select the check box and enter the destination MAC address of the packet.
Type the mask for the specified MAC address to determine which bits a packet's MAC
address should match.
Enter "f" for each bit of the specified source MAC address that the traffic's MAC address
should match. Enter "0" for the bit(s) of the matched traffic's MAC address, which can
be of any hexadecimal character(s). For example, if you set the MAC address to
00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet with a MAC address of
00:13:49:12:34:56 matches this criteria.
Select this option to exclude the packets that match the specified criteria from this
classifier.
Some of the following fields can only be configured for certain Ether types.
Select the service classification of the traffic (FTP or SIP).
Select this option and select the protocol (service type) from TCP or UDP. If you select
User defined, enter the protocol (service type) number.
Chapter 9 Quality of Service (QoS)
111