ZyXEL Communications AMG1312-T10D User Manual page 54

Chapter 6 Wireless
Figure 26 Network Setting > Wireless > General
The following table describes the labels in this screen.
Table 9 Network > Wireless LAN > General
LABEL
Wireless Network Setup
Wireless
Wireless Network Settings
Wireless Network
Name (SSID)
Hide SSID
Client Isolation
MBSSID/LAN
Isolation
54
DESCRIPTION
Select the Enable Wireless LAN check box to activate the wireless LAN.
Note: You must also set the Device's physical WLAN ON/OFF button to ON to use
wireless LAN. The WLAN LED should be on.
The SSID (Service Set IDentity) identifies the service set with which a wireless device
is associated. Wireless devices associating to the access point (AP) must have the
same SSID.
Enter a descriptive name (up to 32 English keyboard characters) for the wireless LAN.
Select this check box to hide the SSID in the outgoing beacon frame so a station
cannot obtain the SSID through scanning using a site survey tool.
Select this to keep the wireless clients in this SSID from communicating with each
other directly through the Device.
Select this to keep the wireless clients in this SSID from communicating with clients in
other SSIDs or wired LAN devices through the Device.
Select both Client Isolation and MBSSID/LAN Isolation to allow this SSID's
wireless clients to only connect to the Internet through the Device.
AMG1312-T10D User's Guide