Table of Contents
Advertisement
Getting started
System setup
Network setup
The main console must have an IP address locating its connection with the
router/SIP server. You can set the console to obtain IP from a DHCP server
or assign a specific IP on your own.
To enable the Auto set IP:
1.
When the console is idle, press MENU
2.
Press
SELECT to choose System Setup.
MENU/
3.
Press
or
to scroll to Network Setup then press
SELECT.
MENU/
4.
Press
or
to scroll to Auto set IP then press
SELECT.
MENU/
5.
Press
or
to scroll to Yes then press
6.
The screen displays Obtain IP from DHCP server?
Press
SELECT to save the setting. There is a
MENU/
confirmation tone.
7.
The screen displays Obtaining IP from DHCP server
Please wait... The process takes up to one minute.
8.
There is a confirmation tone when the IP is
successfully assigned. The screen displays
IP obtained: XXX.XXX.X.X Check network info?
Press
SELECT to read the network info, or press
MENU/
CANCEL to return to the main menu.
•
If the IP did not successfully retrieved, the screen
displays Unable to obtain IP. Please check DHCP
server. briefly, and then Set static IP to this
extension? You may press
the Static IP setting.
.
/SELECT
SELECT.
MENU/
SELECT to enter
MENU/
23
L1
L2
L3
L4
System Setup
Unassign Ext No.
Prime Line
Line Group
Set Line Mode
Set Master
>Network setup
L1
L2
L3
L4
Network setup
>Auto set IP
Set static IP
L1
L2
L3
L4
Auto Set IP
>Yes
No
L1
L2
L3
L4
Obtain IP from
DHCP server?
L1
L2
L3
L4
IP obtained:
192.168.1.3
Check
network info?
Advertisement
Table of Contents
