Table of Contents
Advertisement
Getting started
Table/desktop installation
Option 2: To connect four single line wall jacks
Plug the other end
of the Ethernet
cable into a router
Plug the larger
end of the
console power
adapter into an
electrical outlet
not controlled by
a wall switch.
Plug the small end of the
console power adapter into
the power jack on the back
of the console.
The console takes at least one minute to start up.
IMPORTANT INFORMATION
1.
Use only the power adapter supplied with this product. To order a replacement power adapter, visit
www.telephones.att.com
our website at
1 (866) 288-4268
In Canada, dial
2.
The power adapter is intended to be correctly oriented in a vertical or floor mount position. The
prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the-table or
cabinet outlet.
Plug one end of the
Ethernet cable into the
Ethernet jack at the back
of the console.
Line 4
Router
Plug one end of the telephone
line cord into the L1, L1/2, L3
and L3/4 jack at the back of the
console.
.
8
Plug the another end of the
telephone line into a 1-line
telephone wall jack
Line 3/4
Line 2
Line 1/2
1 (800) 222-3111
,
or call
If you have DSL
high-speed
Internet service,
a DSL filter (not
included) is
required on each
DSL line.
The DSL
filter must be
plugged into the
telephone wall
jack.
.
Advertisement
Table of Contents
