Manual Transmission and Differential
11. Transfer Drive Gear
A: REMOVAL
S503229A18
1) Remove the manual transmission assembly
from vehicle. <Ref. to MT-32 REMOVAL, Manual
Transmission Assembly.>
2) Remove back-up light switch and neutral posi-
tion switch. <Ref. to MT-42 REMOVAL, Switches
and Harness.>
3) Remove transfer case with extension case
assembly. <Ref. to MT-46 REMOVAL, Transfer
Case and Extension Case Assembly.>
4) Remove extension case assembly.
5) Remove transfer driven gear.
6) Remove transfer drive gear.
B: INSTALLATION
1) Install transfer drive gear. (Without oil pump)
Tightening torque:
26 N·m (2.7 kgf-m, 20 ft-lb)
2) Install transfer drive gear to extension case.
(With oil pump)
Tightening torque:
26 N·m (2.7 kgf-m, 20 ft-lb)
CAUTION:
Do not use a press machine. Always install the
parts by hand.
NOTE:
Engage the transfer drive gear pin with the exten-
sion case pin.
TRANSFER DRIVE GEAR
S503229
B3M1986
S503229A11
B3M1986
MT-52
(A)
Oil pump shaft
(B)
Straight pin
(C)
Transfer drive gear
3) Install transfer driven gear.
4) Install the extension case assembly.
5) Install transfer case and extension case assem-
bly. <Ref. to MT-46 INSTALLATION, Transfer Case
and Extension Case Assembly.>
6) Install back-up light switch and neutral position
switch. <Ref. to MT-43 INSTALLATION, Switches
and Harness.>
7) Install the manual transmission assembly from
vehicle. <Ref. to MT-35 INSTALLATION, Manual
Transmission Assembly.>
C: DISASSEMBLY
1) Remove snap ring.
2) Remove ball bearing.
3) Remove straight pin from transfer drive gear.
(With oil pump)
S3M0443B
S503229A06
B3M1988
B3M1989