Troubleshooting; What To Do If - AEG BE1003001M User Manual

The top lamp
1. Turn the lamp glass cover
counterclockwise to remove it.

11. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.

11.1 What to do if...

Problem
You cannot activate or oper-
ate the oven. The display
shows "400" and an acoustic
signal sounds.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
Steam and condensation
settle on the food and in the
cavity of the oven.
The display shows "12.00".
11.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
Possible cause
The oven is incorrectly con-
nected to an electrical sup-
ply.
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
The fuse is blown.
The lamp is defective.
You left the dish in the oven
for too long.
There was a power cut.
The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the appliance
cavity. Do not remove the rating plate
from the appliance cavity.
ENGLISH
Remedy
Check if the oven is correctly
connected to the electrical
supply (refer to the connec-
tion diagram if available).
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Reset the clock.
21