Troubleshooting - AEG BE200302 User Manual

20 www.aeg.com
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.
CAUTION!
Always hold the halogen
lamp with a cloth to prevent
grease residue from burning
on the lamp.

11. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
11.1 What to do if...
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
Steam and condensation
settle on the food and in the
cavity of the oven.
The display shows "12.00".
11.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
or deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
Possible cause
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
The fuse is released.
The lamp is defective.
You left the dish in the oven
for too long.
There was a power cut.
on the front frame of the appliance
cavity. Do not remove the rating plate
from the appliance cavity.
Remedy
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Make sure that the fuse is
the cause of the malfunction.
If the fuse releases again
and again, contact a quali-
fied electrician.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Reset the clock.