Troubleshooting; Definitions And Abbreviations; References - TagMaster XT-1 Installation Manual

XT-1 Installation Manual

6 Troubleshooting

To facilitate troubleshooting, consider the following:
Make sure that the XT-1 has correct supply voltage and sufficient current. Check the small green
LED on the right side of the controller board inside the reader. When the LED is flashing (once per
second) the reader is powered and the firmware is running. If the LED is on, but not flashing, the
reader is powered but the firmware is not running. If the LED is off, the reader is not powered.
If using Ethernet communication, make sure that the network connection is ok. There are small
LEDs on the RJ45 socket, only visible when the lid of the reader is open. A yellow light indicates
'Link' and a flashing yellow light indicates 'Activity'.
If the IP address has been forgotten or firmware settings have been corrupted the reader can be
restored to factory default settings as described in §4.4.
Make sure that working and correctly formatted EPC Gen 2 tags are being used.

7 Definitions and Abbreviations

AES
ASCII
AWG
CR
DES
DIP
EPC
FCC
LED
LF
OEM
RFID
PC
®
SecureMarkID
TAGP
TCP/IP
UMK
USB
XT-1

8 References

[1] 06-147 UMK 193600 D
[2] 05-172 TAGP P
Manuals and documentation can be downloaded from www.tagmaster.com.
Advanced encryption standard
American standard code for information interchange
American wire gauge
Carriage return
Data encryption standard
Dual in-line package
Electronic product code
Federal communications commission
Light emitting diode
Line feed
Original equipment manufacturer
Radio-frequency identification
Personal computer
A TagMaster implementation for improved Security using EPC tags
A TagMaster protocol for RFID reader communication
An Internet protocol suite
Universal mounting kit
Universal serial bus
A TagMaster RFID reader
S
ATA HEET
S
ROTOCOL PECIFICATION
13-111 02, 2014-RO-012, 2014-04-30
Page 29 of 32