Jetusa CX580 User Manual page 8

Petrol Powered Pressure Washers
1. Insert the wheel axles (A) into the tubes (B) on the underside rear of the machine frame. Press the
spring-loaded pin (C) in to insert the axle and ensure that it "pops" through the hole in the tube (D).
2. Place a wheel (E) onto each axle, with the long hub (F) toward the frame. Secure each wheel with a M12
washer (G) and nut (H) and tighten (rotate right) with a suitable spanner.
A
C
B
3. Insert the handle (I), with nozzles facing the front of the machine, into the frame tubes (J). Insert an
extension nut (K) through the holes in the frame tubes and handle from the outside and secure on the
inside using an M6 screw (not shown). Tighten (rotate right) the fasteners using the two Allen keys.
4. Attach the lance bracket (L) to the right-hand side of the handle using 2 M5 screws (M), washers and
nuts (not shown). Tighten (rotate right) the fasteners using a suitable spanner and Allen key.
5. Attach the hose bracket (N) to the left-hand side of the handle using 2 M5 screws (M), washers and nuts
(not shown). Tighten (rotate right) the fasteners using a suitable spanner and Allen key.
J
The machine is now basically assembled. Refer to
E&OE
D
E
M
I
K
Pumps, Hoses and
© 2017 Jet-USA
H
F
G
M
L
Fittings.
N
8