Connecting The Water Supply; Mains Water Supply; Using The Machine To Draw Water - Jetusa CX580 User Manual

Petrol Powered Pressure Washers

Connecting the Water Supply

The machine must be connected to a water supply that can deliver sufficient water for pumping. Most
domestic applications will use a standard garden hose connected to the mains water supply. In cases where
no mains or gravity fed water supply is available, the machine can draw water from a suitable reservoir using
the supplied inlet hose and strainer.
When using a garden hose and mains water supply, it is recommended to run water through the
hose first to flush out any debris BEFORE connecting it to the pump
or water at temperatures above 40°C (104°F) as damage to the pump may result.
machine may void the product

Mains Water Supply

1. Connect a standard garden hose to the water supply and
the pump inlet connector. Ensure that the connections are
secure.
2. Turn ON the water supply.
3. Squeeze the trigger on the lance. When a steady stream
of water is flowing from the nozzle, the machine is ready to
be used.

Using the Machine to Draw Water

The maximum length of the inlet hose is 5m (15'). Do NOT exceed this
hose without the strainer attached. • Do NOT allow the strainer end of the inlet hose to rest at the
bottom of the reservoir as it may allow contaminants into the pump. • When running the engine to suck water
into the pump, do NOT allow it to run for more than 60 seconds. • The pump suction procedure will require
repeating if the machine is switched OFF and / or air gets into the inlet hose.
longer than 60 seconds may permanently damage it and will void the product
1. Connect the supplied inlet hose to the pump inlet connector.
2. Place the free end of the inlet hose into the water reservoir.
3. Start the machine engine and run it at approximately half throttle. The pump will begin sucking in water.
4. Squeeze the trigger on the lance. When a steady stream of water is flowing from the nozzle, the machine
is ready to be used.
E&OE
warranty.
© 2017 Jet-USA
inlet. • Do NOT use hot water
Using hot water in the
limit. • Do NOT use the inlet
Running the pump "dry" for
warranty.
28