Engine Starting; Manual/Pull Starting; Stopping The Engine - Jetusa CX580 User Manual

Petrol Powered Pressure Washers

Engine Starting

Before starting the engine, ensure that you have
followed all procedures described in the
with engine oil, although traces of oil from the manufacturing process may be present. It is essential to add
adequate engine oil of the correct type to the engine before use – see
Failure to add engine oil will void the product
equipment when using the machine. • Inspect the machine before each use and check for wear or damage.
If the machine is damaged, have it inspected and repaired at an authorized service centre before using it
again.
Different models may feature variations in design; for example, some have different engine types etc. The
following procedures and images are typical to all models, however, the position or appearance of controls
etc may vary. All major engine controls are identified on the machine by way of stickers or other markings.

Manual/Pull Starting

1. FUEL – Place the fuel tap (A) in the "ON" position.
2. CHOKE – If the engine is cold, place the choke (B) in
the "COLD" or "CLOSED" position. If the engine is
warm or the ambient temperature is high, place the
choke in the "RUN" or "OPEN" position.
3. IGNITION – Place the engine ON/OFF switch (C) in the
"ON" ("I") position.
4. THROTTLE – Place the throttle control (D) just off the
"SLOW" position.
5. START – Slowly pull out the starter cord (E) until you
feel it engage with the engine, then pull it out rapidly (use both hands if
necessary). The engine should start. Allow the starter cord to rewind slowly – do
not let it "snap" back.
6. WARM-UP – Allow the engine to warm-up and run smoothly. If choke is being
applied, place the choke (B) in the "RUN" or "OPEN" position.
7. THROTTLE – Adjust the throttle control (D) for the required engine speed and
pumping requirements.
If the engine does not start, repeat step 5 onward. If the engine fails to start after several attempts, refer to
Troubleshooting.

Stopping the Engine

Stopping in an Emergency
1. To stop the engine immediately, place the engine ON/OFF switch in the "OFF" position.
Stopping in Normal Use
1. Place the throttle control in the "SLOW" position.
2. Place the engine ON/OFF switch or key switch in the "OFF" position.
3. Place the fuel tap in the "OFF" position.
E&OE
Before Use Checklist. The product is NOT supplied
Checking and Changing Engine
warranty. • Always wear suitable protective clothing and
B
A
© 2017 Jet-USA
Video Tutorial:
Starting 4-Stroke Engines
D
E
Oil.
C
29