Jetusa CX580 User Manual page 14

Petrol Powered Pressure Washers
1. Insert a wheel axle (A) through each wheel (B).
2. Push each axle into the frame axle tube (C).
3. Insert a "R" clip (D) through the hole in the axle, so the axle is secured.
B
The handle can be inserted with the hand-hold bend facing either way. Bear this in mind when you
assemble the hose reel to the handle, as the reel must be mounted so the pump connection
hose is on the left-hand side of the machine. Set out the handle and reel parts before assembling. In the
example images, the handle is being set up so the hand-hold bend is facing the rear of the machine. The
reel can be installed so the pump connection hose fitting and winder sits either in front or behind the handle.
4. Slide the reel brackets (F and G) up the handle (E) tubes approximately 150mm (6"). Secure the
brackets to the handle using 4 M6x15 screws (H) and lock nuts (I) – there are recessed in the brackets
for the nuts. Tighten (rotate right) the screws using the screwdriver.
F
E
5. Insert the handle (E) into the frame tubes (J). Press the spring-loaded pins (K) in so the handle tube can
pass over them. When the pins "pop" through the holes in the handle, the handle is assembled correctly.
J
E&OE
A
G
I
E
© 2017 Jet-USA
C
H
K
D
14