Petrol Powered Pressure Washers
1. Insert the wheel axles (A) into the tubes (B) on the underside rear of the machine frame. Press the
spring-loaded pin (C) in to insert the axle and ensure that it "pops" through the hole in the tube (D).
2. Place a wheel (E) onto each axle, with the long hub (F) toward the frame. Secure each wheel with a M12
nut (G) and tighten (rotate right) with a suitable spanner.
A
C
B
3. Attach the lance / hose bracket (H) to the top right-hand side of the machine frame by inserting the legs
of the bracket through the holes in the frame and securing using 2 nuts (not shown). Tighten (rotate
right) the nuts using a suitable spanner.
The machine is now basically assembled. Refer to
information.
E&OE
E
D
Pumps, Hoses and Fittings
© 2017 Jet-USA
G
F
H
for hose assembly
19