Before Use Checklist; Engine Oil; Air Filter; Fuel - Jetusa CX580 User Manual

Petrol Powered Pressure Washers

Before Use Checklist

Ensure that you carry out all procedures below before starting the engine or operating the
equipment. All procedures described are generic in nature and slight variations between
different models may exist.
correctly may result in making the product warranty
although traces of oil from the manufacturing process may be present. It is essential to add adequate engine
oil of the correct type to the engine before use – see
engine oil will void the product

Engine Oil

Four-stroke engines require engine oil in the crankcase for lubrication of internal components. Severe or
irreparable damage may occur if the engine is allowed to run without engine oil. The engine oil level requires
regular maintenance. Check the engine oil level and ensure that the oil level is at or just under the maximum
level indicator.
Always check the engine oil level before starting the engine. See

Air Filter

The air filter is used to prevent dirt and other particles from possibly entering the engine and causing internal
damage to it. The air filter requires regular maintenance.
Always check the air filter before starting the engine. See

Fuel

Petrol/fuel/gasoline is extremely flammable – keep clear of naked flames or other ignition
sources. • The engine must be cool before refuelling.
Adequately fill the fuel tank with the correct fuel type.
•
Use non-ethanol unleaded petrol (higher RON values will provide best engine performance). Do not use
old or contaminated fuel.
To fill or top up fuel:
1. Place the machine in an upright position on a flat and level surface.
2. Clean the machine around the fuel filler so that no dirt or other material enters the engine when the cap
is removed.
3. Remove (rotate left) the fuel filler cap.
4. Using a funnel, carefully fill the tank with fuel. Do not fill above the top of the strainer (if equipped) or
otherwise overfill the tank.
5. When finished, reinstall (rotate right) the fuel filler cap until firm. Wipe away any residual fuel from the
machine. If fuel has been spilt, move the pump away from the spillage before starting the engine.
Pump Oil – Non-Sealed Pumps Only
Water pumps require oil for lubrication of internal components. Severe or irreparable damage may occur if
the pump is used without oil. The pump oil for non-sealed pumps requires regular maintenance, however,
does come shipped with oil. Check the oil level and ensure that it is at or just under the maximum level
indicator.
Always check the pump oil level before starting the engine. See
E&OE
Failure to follow the checklist and carry out the procedures
void. The product is NOT supplied with engine oil,
Checking and Changing Engine
warranty.
Checking, Cleaning and Replacing the Air
© 2017 Jet-USA
Oil. Failure to add
Checking and Changing Engine
Checking and Changing Pump
Oil.
Filter.
Oil.
26