Jetusa CX580 User Manual page 12

Petrol Powered Pressure Washers
1. Insert a wheel axle (A) through each wheel (B).
2. Push each axle into the frame axle tube (C).
3. Insert a "R" clip (D) through the hole in the axle, so the axle is secured.
B
4. Insert the handle (E) into the frame tubes (F). The handle can be inserted with the hand-hold bend facing
either way. Press the spring-loaded pins (G) in so the handle tube can pass over them. When the pins
"pop" through the holes in the handle, the handle is assembled correctly.
E
F
Insert the ends of the hose hanger (H), from the rear of the machine and with the "hooked" section facing up,
through the holes (I) in the handle. Secure the hanger with the nuts and washers. Tighten (rotate right) the
fasteners using a suitable spanner.
H
The machine is now basically assembled. Refer to
E&OE
C
A
Pumps, Hoses and
© 2017 Jet-USA
D
G
Fittings.
12