Hitachi EM-G21 User Manual page 56

STATEMENT ON FCC COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Note: This device has been tested and found to comply with the limits for Class B
digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This device generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio or
television reception, which can be determined by turning this device off and on. The
user is encouraged to try to correct the interference by one or more of following
measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between this device and receiver.
 Connect this device into an outlet on a circuit different from that to which the receiver
is connected.
 Consult the dealer or an experienced radio/TV technician for help.
Modifications: The FCC requires the user to be notified that any changes or
modifications to this device that are not expressly approved by the party responsible for
compliance could void the user's authority to operate this device.
CAUTION
Exposure to Radio Frequency Radiation.
The radiated output power of the wireless LAN facility built in this device (the "Wireless
LAN") is far below the FCC radio frequency exposure limits. Nevertheless, the
Wireless LAN shall be used in such a manner that the potential for human contact
during normal operation is minimized. In the usual operating configuration, the
distance between the antenna and the user should not be less than 20 cm. Please
follow instructions in this manual for the details regarding antenna location.
- 41 -