Setup Of Mac Address Filtering - Hitachi EM-G21 User Manual

5.2 Setup of MAC Address Filtering

If you wish to specify MAC address filtering for the user PC that connects to the Gateway
via encrypted wireless LAN, follow the procedure below.
1. Do Steps 1 to 7 of Subsection 5.1.2.
2. If you wish to enable MAC address filtering for SSID-1, check enable check box in
"MAC Address Filtering" field of "SSID Configuration" section on the SSID Entry
Editor page. Finally, click Set button on the same page.
3. Click Wireless from menu to drop down the list and click MAC Filtering in the list.
4. The SSID Entry Editor page navigates to the "MAC Filtering" page shown below.
5. In "MAC Address" field of "Accept MAC Address" section, type the MAC address of
the user PC for wireless connection according to the rules below.
 Hexadecimal letters (0 to 9, a to f, and A to F; not case sensitive) and colon (:) in
the form of "xx:xx:xx:xx:xx:xx" are accepted. If the user PC shows a hyphen (-)
as a separator, use a colon instead of each hyphen when you type.
 Do not specify the same MAC address in two or more entry fields.
6. Click Set button on the same page to register the specified MAC address to the
Gateway.
7. Close the browser to log out from the "EMS Gateway" setup page. Resume firewall
and/or antivirus software if terminated in Step 1.
- 18 -