Wired Lan Connection - Hitachi EM-G21 User Manual

4.2 Wired LAN Connection

Where wired LAN connection to the Gateway is necessary, follow the procedure below.
For how to operate the destination equipment such as PC or sensor, refer to instruction
manual of the destination equipment.
1. Referring to instruction manual of the destination equipment, set up the wired LAN
connection of the destination equipment so that the IP address of the destination
equipment is automatically assigned by DHCP server (the Gateway).
2. Turn off power of the Gateway and turn off power of the destination equipment.
3. Prepare a LAN cable, either provided by the Gateway or procured according to
Subsection 1.3.3. Connect this LAN cable between the LAN port of the destination
equipment and one of the LAN ports LAN1 through LAN4 in the rear access area of
the Gateway until you hear a click from each port connection. When performing
this connection on the Gateway mounted on the wall, support the Gateway by hand
to avoid extra mass.
Note: Equipment layouts and destination connection shown above are for
reference only. These layouts and connection must be made according to actual
environment of the user premise.
4. Turn on power of the Gateway. Ensure that the LINK lamp of the subject port on
the Gateway turns on in green.
5. Turn on power of the destination equipment. Ensure that the LINK lamp of the
subject port on the Gateway stays on or blinks in green.
(area of LAN ports only)
- 14 -