Hitachi EM-G21 User Manual page 24

2. By moving the temporarily-combined Gateway and the stand around on the wall,
determine the target location on the wall for securing the stand where all of the
following conditions meet:
 There is no other device or wall within 5 cm of three open sides, top, and bottom
of the Gateway.
 There is no strong shock or vibration.
 There is enough strength to support the mass of the Gateway.
 There is enough thickness so that the tip of the wall-mounting screw may not
damage cables routed behind the wall or thrust out the other side of the wall in
the next room.
3. Detach the Gateway from the stand by sliding the hook plates on the equipment
label side of the Gateway away from the mating slots on the front surface of the
stand until they come off.
4. Place the stand to the target location with the apex of triangle facing up and then
secure the stand firmly to the wall with the attached two wall-mounting screws.
Apex of triange facing up
- 9 -