Henny Penny
7-13. POWER SWITCH
7-14. RADIANT HEATERS
7-10
1. Remove electrical power supplied to the unit.
Remove electrical power supplied to the unit by
unplugging the unit, or by turning off the wall
circuit breaker, or electrical shock could result.
2. Remove the control side-side panel.
3. Remove and label wires from switch.
4. Check for continuity of switch.
5. If switch proves bad, squeeze the flanges on the back side
of the switch and pull switch from front of panel.
6. Replace switch in reverse order, and restore power to unit.
1. Remove electrical power to unit.
Remove electrical power supplied to the unit by
unplugging the unit, or by turning off the wall circuit
breaker, or electrical shock could result.
2. If removing air heaters, remove ceiling vent. (See
Section 3-12.)
3. Using a Phillips head screwdriver, remove the screws
securing the heater to the unit.
SCR-6/8
698