Henny Penny SCR-8 Service Manual page 20

Henny Penny
3-12. CLEANING
PROCEDURES
(continued)
3-10
5. Loosen the thumb screw on the blower fan blade and pull
blade from shaft. Then take fan blade to a sink to clean
thoroughly.
When reinstalling fan blade, be sure the offset shaft
matches up, and the thumb screw is tightened snug, but
not too tight. If the fan is not installed properly the fan
could hit the vent cover and damage to the fan could
result.
Do not use abrasive cleaners or cleaners/sanitizers con-
taining clorine, bromine, iodine, or ammonia chemicals.
These abrasives and chemicals will deteriorate the
stainless steel material and shorten the life of the unit.
Futhermore, when cleaning the coated parts, Do Not
use any abrasive cloth, degreaser, oven cleaner, or any
type of corrosive cleanser. Hot soapy water is all that is
needed to clean these parts. Any of the other cleaners
mentioned above will greatly reduce the life of the
coating.
SCR-6/8
698