Socket - Halogen Lamp; Power Switch - Henny Penny SCR-6 Technical Manual

2-12. SOCKET - HALOGEN
LAMP
Step 4
Step 5

2-13. POWER SWITCH

Step 3
Step 5
2-10
1. Remove electrical power supplied to unit.
To avoid electrical shock or property damage, move
the power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Remove appropriate side panel.
3. Remove halogen lamp from socket. (See Halogen Lamp
Replacement Section.)
4. Cut wires going to the socket, at the white wires, behind the
splicers.
5. Remove the two Phillips head screws securing the socket and
remove socket from unit.
6. Splice wires of new socket onto existing wires and install
socket and lamp back into unit.
7. Replace side panel and restore power to unit.
1. Remove electrical power supplied to the unit.
To avoid electrical shock or property damage, move
the power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Remove the side panel closest to the controls.
3. Remove and label wires from switch.
4. Check for continuity of switch.
5. If switch proves bad, squeeze the flanges on the back side of
the switch and pull switch from front of panel.
6. Replace switch in reverse order , and restore power to unit.
SCR-6/8
306