Henny Penny
7-14. RADIANT HEATERS
(continued)
7-15. CONTROL BOARD
"SPEAKER"
REPLACEMENT
698
4. Remove the wires from the terminals.
5. Remove screws from both support brackets, and pull brack-
ets and heater from unit.
6. Install new heater in reverse order.
1. Remove electrical power supplied to the unit.
Remove electrical power supplied to the unit by
unplugging the unit, or by turning off the wall circuit
breaker, or electrical shock could result.
2. Remove control side-side panel from unit.
3. Unplug the red connector from the board.
4. Using a Phillips head screwdriver, remove the two screws
securing the speaker and remove the speaker.
5. Replace with new speaker in reverse order.
SCR-6/8
7-11