Installation Of Discs, Rods, And Spits - Henny Penny SCR-8 Service Manual

Henny Penny
3-3. INSTALLATION OF DISCS,
ROD AND SPITS
698
1. Fit discs up to appropriate disc support on each side
of unit.
2. Place each end of the rod assembly into the hubs on
each disc.
3. Slide the collars onto each hub of discs.
4. Slide retention rings over hubs and into slot on rod.
5. Slip angled spits onto discs, with the "V" of the angled
spits towards the rod.
Fit the spit with the "V" towards the rod. Revers-
ing the spit will result in spits tilted at an angle.
When removing the rod assembly make sure
indicator is pointed up towards top of unit. If it is
pointed down, the rod assembly will fall.
NOTE
SCR-6/8
3-5