Rotation Control Switch - Henny Penny SCR-8 Service Manual

Henny Penny
7-7. DRIVE MOTOR
REPLACEMENT
(continued)
7-8. ROTATION CONTROL
SWITCH
7-6
5. Remove lock nut and nut from the bolt in the extension
hub, and remove bolt.
6. Separate the extension hub from drive motor shaft.
7. Install extension hub into new motor.
8. Slide extension hub into slot and bolt the motor to the bracket.
Snug, but don't tighten nuts.
9. Install discs into unit and place rod into place.
10. Adjust motor on bracket so no more than 1/16" gap is present
and the end of the rod is even all around hub.
The rod must not have much "play" in it from the disc hub.
The gap between the end of the rod and the hub should not be
more than 1/16".
11. Once rod is "lined" up, tighten nuts on bracket.
12. Splice wires of motor onto the cut wires, according to colors.
13. Replace side panel and restore power.
A vent plug is sent separately with the drive motor and
needs to be threaded onto the new motor upon installation.
1. Remove electrical power supplied to unit.
Remove electrical power supplied to the unit by unplugging
the unit, or by turning off the wall circuit breaker, or
electrical shock could result.
2. Remove screws securing control side side-panel and remove
panel.
3. Remove and label wires from terminals of switch.
NOTE
SCR-6/8
698