Henny Penny SCR-8 Service Manual page 25

Henny Penny
4-3. SPECIAL PROGRAM MODE
(continued)
4-5
Audio Tone (SP-5)
The tone of the speaker can be adjusted. After entering the access
code (1,2,3), press the P button four times. "AUDIO TONE
shows in the top display, and a number 50 thru 2000 shows in the
middle display. 50 is the lowest tone setting, 2000 being the
highest. Use the Up and Down buttons under the number to set
the desired tone.
Alarm Auto Cancel (SP-6)
After entering the access code (1,2,3), press the P button five times.
"ALARM AUTO CANCEL" shows in the top display, and "YES"
or "NO" shows in the middle display. If this is set at YES, then
when the programmed alarms go off the speaker will sound sev-
eral beeps, then automatically stop. If it is set to NO, then some
one has to press the alarm button before the speaker stops beeping.
Use the Up and Down buttons under the middle display to toggle
from YES to NO, or vice versa.
Cook-to-Hold-Auto (SP-7)
After entering the access code (1,2,3), press the P button six times.
"COOK-TO-HOLD-AUTO" shows in the top display, and "YES"
or "NO" shows in the middle display. If this is set to YES, then at
the end of a cook cycle the speaker will beep several times and
automatically goes into the Hold mode. If it is set to NO, then
someone has to press the STOP button before the speaker stops
beeping and the Hold cycle starts. Use the Up and Down buttons
under the middle display to toggle from YES to NO, or vice versa.
Idle Mode Enabled (SP-8)
After entering the access code (1,2,3), press the P button seven
times. "IDLE MODE ENABLED" shows in the top display, and
"YES" or "NO" shows in the middle display. If this is set to YES,
then "IDLE"... "SELECT PRODUCT"... "PUSH START TO
PREHEAT" will scroll across the top display when the rotisserie
is not in use. If it is set to NO, then at the end of a cook cycle the
unit will start preheating again for the next cook cycle. Use the Up
and Down buttons under the middle display to toggle from YES to
NO, or vice versa.
Multiple Cook Steps (SP-9)
After entering the access code (1,2,3), press the P button eight
times. "MULT COOK STEPS" shows in the top display, and
"YES" or "NO" shows in the middle display. If this is set to YES,
then more than one step can be programmed during a cook cycle.
If it is set to NO, then only one time and temperature can be
programmed per cook cycle. Use the Up and Down buttons under
the middle display to toggle from YES to NO, or vice versa.
SCR-6/8
698