Changing The Engine Oil - HAKO Citymaster 2000 Operation And Maintenance Instructions

1411.22 euro 4
Table of Contents

Advertisement

Maintenance
4.3.4

Changing the engine oil

10 l
Fig. 102:
4-12
Important!
Change the engine oil and the engine oil filter for the first time
after 50 operating hours as well as after the first 300 operating
hours, then every 300 operating hours, at the latest every year.
Specification (see page 4-62)!
Change the engine oil as follows:
Warm up the engine
As soon as the oil temperature is about 80 °C:
Park vehicle on level ground and secure against rolling away
Raise the dirt hopper and check the position of the safety strut (see
page 3-65)
Switch off the engine, pull the ignition key
Place an oil drip pan (with a capacity of at least 10 litres) under the
engine
Unscrew oil drain plug C
Completely drain the oil
Turn in oil drain plug C with a new sealing ring and tighten it to 30 Nm
Fill in engine oil (see page 4-11)
Danger!
Start the engine and run at low speed for a short time
Warning light 84 must go off after a few seconds
Switch off the engine
Check the oil level again
+ 80 °C
Top up if necessary and check again
Completely remove any oil spilt on the engine
C
Danger!
Caution when draining hot engine oil –
Risk of burns!
Wear protective gloves and goggles
Use suitable tools – e.g. for unscrewing the oil drain plug
Environment!
Collect the drained engine oil in a suitable container and dispose
of it according to local or national environment protection regula-
tions!
Keep waste oil safely away from children!
X56b510.fm

Advertisement

Table of Contents
loading

Table of Contents