Table of Contents
Advertisement
Maintenance
4 Maintenance
4.1
Introduction
4.1.1
Accessibility to assemblies
X56b510.fm
Before carrying out service and maintenance work, always read, under-
stand and follow the instructions given in
•
Section 2 "SAFETY INSTRUCTIONS" of this operation manual
•
The instructions in the operation manuals of the implement equipment
manufacturers
Daily and weekly service and maintenance work can be performed by a
specially trained operator. All other maintenance work must be carried out
by trained and qualified mechanics only.
All warranty claims become obsolete in case of nonobservance and the
resulting damage!
For the repair and maintenance of the Citymaster, our wide network of
contract dealers and workshops with trained specialists, modern equip-
ment and all necessary special tools is available. Here you can obtain
advice from specialists as well as fast and effective help.
The maintenance plans (see page 4-63) state when the maintenance
work mentioned below must be carried out.
Assemblies to be serviced are accessed as follows:
•
Wash water tank for windscreen washer unit, fuse box, relay
In cab
•
Air filter, oil dip stick for engine oil
Behind the cab
•
Hydraulic oil tank, suction/return filter hydraulics, fuel tank
On the left of the chassis
•
Coolant expansion tank
On the right of the chassis
•
Cooling system, radiator
With the right radiator cover removed
•
Filling opening for engine oil, engine oil filter, fuel filter, breather filter of
hydraulic oil tank, battery, grease nipple of parking brake camshaft
Raise the dirt hopper and check the position of the safety strut (see
page 3-65) and removed engine cover (see page 4-2)
•
Brake-fluid tank, V-ribbed belt alternator/water pump
•
Engine oil drain plug, axles
•
Differentials of front and rear axle, drive axles, cardan shaft to rear axle,
transfer gearbox
•
Drive hydraulics pressure filter
From underneath the vehicle
Maintenance
4-1
Advertisement
Table of Contents
