Installation Of Water Supply Connector - AQUALUX AQLXC-5RO Operating Manual

WARNING: CONNECT TO COLD WATER ONLY.
CONNECTING THE REVERSE OSMOSIS HEAD ASSEMBLY TO
HOT WATER WILL DAMAGE THE MODULE AND VOID THE
WARRANTY.
1. Turn off the cold water supply to the sink faucet by locating the round or oblong handle on the right side
of the sink cabinet and turning clockwise until water supply is off. If you are not sure which is the cold
water line, turn on the hot water for a few minutes and feel the pipes.
NOTE: Some mixing type faucets may require that the hot water by shut off as well. If the cold water shut-off
valve fails to turn off the water, the house water supply can be turned off at the main.
2. The water supply adaptor can be installed at the faucet connection of the cold water line or at the shut-
off valve connection. Typical installations below:
3. Disconnect the threaded nut at the connection and thread the water supply adaptor, with the flat washer
and cone washer in place, onto the connection and tighten. Connect the tubing to the water supply to the
sink faucet and check for leaks.

INSTALLATION OF WATER SUPPLY CONNECTOR