Pre-Installation Inspection - AQUALUX AQLXC-5RO Operating Manual

This reverse osmosis unit is thoroughly tested before shipment. Test procedures include:
1. Quality test of the product water produced to assure that minimum standards of impurity rejection are
met.
2. Test of all components to assure correct function.
3. Flow rate measurement to assure that efficiency specifications are met.
The feed water supply must comply with the following conditions for the warranty to remain valid.
1. Temperature Range – 40 degrees Fahrenheit to 85 degrees Fahrenheit
2. Water Pressure – 40 psi to 70 psi
3. Maximum Total Dissolved Solid CTA Membrane 1500 ppm
Maximum Total Dissolved Solid TFC Membrane 2500 ppm
4. pH Range
CTA Membrane 5.0 to 8.0
TFC Membrane 3.0 to 11.0
5. The system must be connected to COLD water supply only.
6. Do not allow unit to freeze. The membrane always contains water and will be destroyed if frozen.
7. Do not use where the water is microbiologically unsafe or with water of unknown quality without
adequate disinfection before or after the unit.
8. All local plumbing codes are to be followed.
After opening the shipping container, locate the following items
1. Reverse Osmosis Head Assembly
2. Storage Tank
3. Long reach Faucet with Mounting Hardware
4. Water Supply Connector (optional)
5. Drain Saddle (optional)
6. Four colors of polyethylene tubing
7. Storage tank shut off valve with tube connection
FACTORY PREPARATION
WARNING
PRE INSTALLATION INSPECTION