AQUALUX AQLXC-5RO Operating Manual page 8

NOTE: This system includes a standard sink top long reach faucet without an air-gap. In localities where
plumbing codes require installation of an air-gap, contact the distributor to obtain an air-gap faucet.
It is recommended that the system representative be consulted for proper tools, techniques and other assistance
in performing the following procedure.
The units manufacturer accepts no responsibility for sink top damage resulting from this installation.
SAFETY GLASSES should be worn to protect your eyes while drilling the faucet hole.
1. For best results a ½" carbide tipped masonry drill bit should be used to drill the sink hole for the long
reach faucet.
2. Carefully select the faucet location confirming it will have a neat water fall pattern and that the faucet
stud will be accessible from below once the hole is completed.
NOTE: If the faucet stud will not be long enough, an extension is available from your distributor.
3. PORCELAIN SINKS: Before starting the drill motor, apply firm downward pressure on the drill bit
until a crunching occurs. This will help keep the drill bit from walking when starting the hole.
4. STAINLESS STEEL SINKS: Before using the ½" carbide drill bit, an indent should be made with a
center punch to keep the drill bit from walking. A small pilot hole will cause excessive wear on the bit
and progress will be slow.
5. Keep steady firm downward pressure while drilling the hole. Too little during the start of the hole will
cause excessive wear on the bit and progress will be slow.
6. Once the hole is completed, immediately clean the area of metal chips and roughness around the hole.
Metal chips will stain porcelain sinks.
INSTALLATION OF LONG REACH FAUCET