5/ Use; Checking The Water Parameters - AQUALUX DUO Electrolyse + pH 105448 Installation And Care Instruction

5/ USE

You have to make these operations before the switched on of the device.
1

CHECKING THE WATER PARAMETERS

When installing the device or at the beginning of any new season, it is imperative to check and correct all the
following points :
State of the water
Temperature of the
water
pH
Stabilizer level
Free chlorine rate
TAC / TH
Be careful : the non-compliance with these recommendations will involve inevitably a misuse of the device
which entails the annulation of guarantee.
DUO AQUALUX – PAPI004070 – FR – EN – DE – Rev.03.16
Clear, free from seaweeds and sediments.
Superior to 15°C
Important: Any use under this temperature entails accelerated wear of the cell and
entails the annulation of guarantee.
Stabilized between 7.0 and 7.4
hatever is the system of chemical process, the efficiency of the chlorine
Important: W
decreases very quickly with the increase of the pH and the scale deposits appear all
the more fast as the pH rate is high or unstable.
To maintain then your pH in the recommended range, use exclusively a pH corrective
product (acid or basic) advised by your professional. For your comfort, we recommend a
device to settle an automatic regulation of the pH.
Less than 35 ppm (mg/l).
Important: The role of the stabilising agent or isocyanurique acid is to protect the chlorine from the
effects of UV. A too important rate will have for consequence to surround the disinfecting effect of
the chlorine produced by the device. Lower the rate of stabilizing agent in your pool by following the
recommendations of your professional.
Around 1 ppm (mg/l). If necessary, make a chlorination shock.
The water must be correctly balanced (TAC, TH) :
 The TAC (Permanent Hardness) indicates the bicarbonates rate dissolved in
water.
 The TH indicates the hardness of water; it means the content in salts of
calcium or magnesium dissolved in water. The hardness of water should not
exceed 60°f.
13