Kontron mITX-SKL-S-C236 User Manual page 76

Sub-Screen Function
TraceHub Configuration Menu
Pch Thermal Throttling Control
SB Porting Configuration
DCI enable (HDCIEN)
Settings
Connected Device
Serial IO ChipSelect Polarity
SPI0
Settings
Serial IO Bluetooth Device
UART0
Settings
Wireless Charging
Mode
Hardware Flow
Control
Serial IO GPIO IRQ Route
GPIO
Settings
WITT/MITT Test Device
UART Test Device
Additional Serial IO devices
SerialIO timing parameters
UCSI/UCMC device
TraceHub Enable Mode
MemRegion 0 Buffer Size
MemRegion 1 Buffer Size
Thermal Throttling Level
DMI Thermal Setting
SATA Thermal Setting
www.kontron.com
mITX-SKL-S-C236 Doc. Rev. 1.1
Description
Indicate what type of device
is connected to this serial IO
controller
Sets initial polarity for
ChipSelect signal
Enables/Disables the
vendor Sensor
Set the wireless charging
mode
When enabled configures
additional 2 GPIO pads for
use as RTS/CTS signals for
UART
Route all GPIO to one of the
IRQ
Choose if WITT Device is
used and with which
controller
Choose if UART Test Device
is used and with which
controller
When enabled, ACPI will
report additional devices
connected to Serial IO
SerialIO timing parameters
(test only)
When enabled, ACPI will
report UCSI/UCMC device
Select Enable, Disable or
Debugger
Select size of mem region 0
buffer
Select size of mem region 1
buffer
Determine if use Intel
suggested setting
Determine if use Intel
suggested setting
Determine if use Intel
suggested setting
SB Porting Configuration
When DCI enable, it is taken
as user consent to enable
// 76