Table of Contents
Advertisement
Sub-Screen
Function
DIMM SPD Alias Test
Receive Enable Centering 1D
Retrain Margin Check
Write Drive Strength Up/Dn
independently
CMD Slew Rate Training
CMD Drive Strength/ Tx
Equalization
CMD Normalization
Memory Configuration
MRC ULT Safe Config
Maximum Memory Frequency
HOB Buffer Size
ECC Support
Max TOLUD
SA GV
SA GV Low Freq
Retrain on Fast Fail
Command Tristate
Enable RH Prevention
Row Hammer Solution
RH Activation Probability
Exit on Failure (MRC)
MC Lock
www.kontron.com
mITX-SKL-S-C236 Doc. Rev. 1.1
Description
Test to determine if the SPD
has been corrupted to
cause memory aliasing
Enable/Disable Receive
Enable Centering 1D
Enable/Disable Retrain
Margin Check
Enable/Disable Write Drive
Strength Up/Dn
independently
Enable/Disable CMD Slew
Rate Training
Enable/Disable CMD Drive
Strength/ Tx Equalization
Enable/Disable CMD
Normalization
Display Memory
Configuration
MRC ULT Safe Config for PO
Maximum Memory
Frequency Selections in
Mhz
Size to set HOB Buffer
Enable/Disable DDR ECC
Support
Maximum value of TOLUD
System Agent Geyserville
System Agent Geyserville.
Set frequency for low point
Restart MRC in Cold mode if
SW MemTest fails during
Fast flow
Command Tristate Support
Activity prevent Row
Hammer
Type of method used to
prevent Row Hammer
Used to adjust MC for
Hardware RHP
Exit on Failure for MRC
training steps
Enable/Disable capacity to
lock or not MC registers
// 58
Advertisement
Table of Contents
